Bakerella's Cake Pops Recipe
Exclusive from The Daily Meal
Not only can you make cake balls and turn them into cake pops, but you can also mold them into other shapes using a small metal cookie cutter. For these cupcake pops, use a flower-shaped cookie cutter. Take them to the next level of cuteness by using more than one color of candy coating and adding sprinkles and candy for decoration.
Adapted from “Cake Pops” by Angie Dudley.
- 18¼-ounce box of cake mix
- 16-ounce container ready-made frosting, any flavor
- 32 ounces (2 pounds) chocolate candy coating
- 16 ounces pink candy coating
- M&M’s or other similarly shaped candy
One 9-by-13-inch cake pan
Large mixing bowl
Large metal spoon
2 baking sheets
Flower-shaped cookie cutter (1¼ inches wide by ¾ inch deep)
2 deep, microwave-safe plastic bowls
48 paper lollipop sticks
Styrofoam block, prepared (see note)
Bake the cake as directed on the box, using a 9-by-13-inch cake pan. Let cool completely.
Once the cake is baked, get organized and set aside plenty of time (a few hours) to crumble, roll, shape, dip, and decorate 4 dozen cupcake pops.
To crumble the cooled cake into a large mixing bowl, cut a baked 9-by-13-inch cake into 4 equal sections. Remove a section from the pan, break it in half, and rub the two pieces together over a large bowl, making sure to crumble any large pieces that fall off (the texture of the cake causes it to crumble easily). You can also use a fork to break any larger pieces of cake apart. Repeat with each section until the entire cake is crumbled into a fine texture. If you have large pieces mixed in, the cake balls may turn out lumpy and bumpy, so make sure there aren’t any large cake pieces.
Add three-quarters of the container of frosting (you will not need the remaining frosting). Mix it into the crumbled cake, using the back of a large spoon, until thoroughly combined. If you use the entire container, the cake balls will be too moist.
The mixture should be moist enough to roll into 1½-inch balls and still hold a round shape. After rolling the cake balls by hand, place them on a wax paper-covered baking sheet.
Cover with plastic wrap and chill for several hours in the refrigerator, or place in the freezer for about 15 minutes. You want the balls to be firm but not frozen.
To shape the pops, remove the baking sheet from the refrigerator. Take a chilled ball and roll it into a cylinder. Then slide it into the flower-shaped cookie cutter. The cake mixture should fill the entire cutter, with any excess forming a mounded cupcake top on one side. You can use your thumb to keep the shape flat on one side, allowing the rest to form a mound on the other. When you have the shape the way you like it, gently push the shaped cupcake out of the cutter from the bottom. If the mixture is still firm enough, you should also be able to gently pull it out by holding the top mounded side.
Place the cupcake-shaped cake ball, mounded-side up, back on the wax paper-covered baking sheet. Continue with the remaining cake balls.
Once the balls are all shaped into cupcakes, return them to the freezer for 5-10 minutes to keep them firm.
To dip the pops, place the chocolate candy coating in a deep, microwave-safe plastic bowl. These bowls make it easier to dip the cupcake bottoms completely in candy coating while holding the bowl without burning your fingers. (I usually work with about 16 ounces of coating at a time.)
Melt the chocolate candy coating, following the instructions on the package or microwaving on medium power for 30 seconds at a time, stirring with a spoon in between. You can also use a double boiler. For any method, make sure you do not overheat the coating.
Now you’re ready to dip. Take a few cupcake-shaped cake balls at a time out of the freezer to work with. Transfer the rest to the refrigerator at this point, so they stay firm but do not freeze.
One at a time, take a cupcake-shaped cake ball and, holding it by the mounded top, dip the bottom into the melted chocolate candy coating — just to the point where the mounded shape starts. Remove it from the chocolate, turn it upside down, and swirl your hand in a circular motion. This will cause any excess chocolate coating to slide down. When the coating reaches the bottom of the mounded cupcake top shape, you can stop. Have a dish towel handy to wipe off your fingertips, as it is highly likely that you’ll get some coating on them. Don’t use water to rinse your hands, as getting water in the coating can make it unusable.
Place the half-coated cupcake shape on the second wax paper–covered baking sheet, coating-side up and mounded side down. Immediately dip about ½-inch of the tip of a lollipop stick into the melted candy coating, and insert the stick straight into the flat, chocolate-coated bottom of the cupcake while the chocolate is still wet. Push it no more than halfway through.
Continue with the rest of the cupcake-shaped cake balls.
Allow the chocolate to dry completely.
Melt the pink candy coating the same way that you melted the chocolate, to decorate the tops. (It’s essential to work quickly here).
Holding it by the lollipop stick, dip the top of each cupcake in the melted pink candy coating; it should completely cover the rest of the exposed cupcake and meet the edge of the chocolate coating.
Remove the cupcake pop from the coating and turn it right-side up. If the coating is too hot, it will start to drip down the sides. If this happens, let the coating sit for a few minutes to cool and start to thicken. Then, when you dip the tops, the coating will stay in place.
To decorate the pops, you first want to fix and uncovered areas. While the coating is still wet, use a toothpick to touch up any areas gaps in the coating. Then place 1 M&M (M-side down) on the top and add sprinkles for decoration.
Place the cupcake pop in a prepared* Styrofoam block to dry completely. Repeat with the remaining cupcake pops.
Store the cupcake pops in an airtight container on the counter or in the refrigerator for several days. You can also cover them in small treat bags, tied with a ribbon, and leave them in the Styrofoam block on the counter.
*Note: Poke holes in the Styrofoam block before you start dipping, using a lollipop stick. Leave enough space between the holes so the cakes won’t touch.
Tips on Making Bakerella’s Cupcake PopsServings: 48
Be a Part of the Conversation
Have something to say?
Add a comment (or see what others think).